35g GEELANG WASP V2 FPV Racing Drone
35g GEELANG WASP V2 FPV Racing Drone
Specifications:
Brand: GEELANG
Item Name: WASP V2 2S Toothpick FPV Racing Drone
Wheelbase: 100mm
Size: 79x79x45mm
Weight: 35g(without battery)
Motor
Motor Mode: GL0802 14000KV
Configu-ration: 9N12P
Stator Diamter: 8mm
Stator Length: 2mm
Shaft Diameter: Φ1mm
Motor Dimension(Dia.*Len): Φ10.5mm*14.5mm
Weight(g): 1.9g
No.of Cells(Lipo): 1S-2S
Flight Controller
& 4 In 1 ESC
Flight Controller：Play F4 whoop
Version: F411CEU6
MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board Size: 28.5 * 28.5mm
Power Supply: 1-2S Battery Input (DC 3.2-8.4V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD (SPI Control)
Built-in 5V 2A BEC
Built-in Voltage Detection
Firmware Version：Betaflight Configurator4.2.0
Onboard 4 In 1 ESC Onboard MCU upgraded to EFM8BB21
Power Supply: 1-2S LiPo/LiPo HV (3.5v/8.7v)
Con. Current: 5A
Peak Current: 7A (3 seconds)
Support BLHeliSuite Programmable
Factory Firmware: S_H_50_REV16_77.HEX
Default Protocol: DSHOT300
Power Input: XT30
Frsky NON-EU/EU-LBT XM+ Receiver
Frsky NON-EU/EU-LBT XM+ receiver Version SBUS receiver
Frsky D8/D16 switchable
CompatiblelNon EU transmitter both D8 and D16 mode
Channels: 8CH or 16CH
Failsafe Support
No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m
Operating Voltage Range: 3.7~10V
Operating Current: 30mA @5V
Operating Range: Full Range
With RSSI Output on Board: Analog 0~3.3V
Firmware upgrade-able, can be upgrade to EU-LBT with RSSI
Frsky AC900 Receiver
Frsky AC900 receiver Version SBUS receiver
Frsky D16 switchable
Compatible Non EU transmitter both D16 mode
Channels: 8CH or 16CH
Failsafe Support
No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m
Frsky D8 Receiver
Frsky D8 receiver Version SBUS receiver
Frsky D8 Compatible Non EU transmitter both D8 mode
Channels: 8CH
Failsafe Support
No Ground Interference ( Transmitter and receiver 1 m from the ground): 200m
Flysky Receiver
Flysky receiver Version IBUS receiver
Protocol: AFHDS-2A
Channels: 14ch(AFHDS-2A)
No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m
Failsafe Support
DSM2/DSMX Receiver
DSM2/DSMX receiver version Serial bus receiver
Protocol: DSM2/DSMX Compatible
Channels: 6-9CH (Depend on your radio)
No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m
TBS NANO Receiver
TBS NANO receiver version CRSF Protocol , Official TBS transmitter compatible
Protocol: CRSF
Channels: 8CH
Failsafe Support
No Ground Interference ( Transmitter and receiver 1 m from the ground): 500m
PNP
PNP receiver version Support any bus and other protocols, users can install by themselves
VTX
5.8G VTX Power Switching: Third Gear(25MW 、 100MW 、200MW)
Frequency: 40CH
Input Voltage: 3.3V 5.5V
Current Consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 Channels
With Raceband
Smartaudio Ready(Frsky EU-LBT and DSMX version not compatible)
Weight: 2.0g
Camera
Camera GL950PRO: 1/4 COMS sensor
Horizontal: 800TVL 800×600
TV System: Ntsc 4:3 non-changeable
Power Input: DC 5-12V
FOV: F1.2
Colorful: 0.1Lux(F1.2,50IRE,AGC ON)
Black and White: 0.01Lux(F1.2,50IRE,AGC ON) Lens: m7
Signal to Noise Ratio: > 50dB Dynamic Range: >60dB
White Balance: Auto White Balance
Image: Color
BLC: Stand By
Video Format: NTSC
Weight: 1.5g
Propeller
Propeller Brand: Gemfan
Item Name: 65MM 1mm PC propeller
Length/Inch: 65mm
Pitch/Inch: 25mm
Color: Red
Material: PC
Weight: 0.4/piece
Recommended Battery (No Included)：
Species : Lipo/LipoHV
Capacity: 250mAh/300mAh/450mAh
Voltage: 3.8V
Continuous Discharge Rate: 30C
Instantaneous Discharge Rate: 60C
Connector: XT30
Features:
1. Use Play F4 flight controller to support 1-2s lithium battery power. Integrated Betaflight OSD function, display the flight voltage, receiver signal, and can observe the situation in real time during the flight.
2. Prepare Smartaudio, change the VTX frequency band and channel through OSD.
3. Adjust the settings and PID of the flight controller via OSD
4. 2S ultralight toothpick drone has strong power, low noise and long flight time.
5. Support Betaflight adjustment, multiple flight modes, carefully adjusted by the original factory, suitable for novice flight practice, stable style.
6. The nacelle cover is made of a one-piece injection molded plastic of a special material. Sturdy structure and light weight. It supports multiple camera adjustments. If there is enough space, the heat dissipation effect will be better.
7. The receiver version is used independently, and the electronic control is more stable. The flight control adopts the newer version of bf4.2, the ESC adopts version 16.77, the bidirectional DSHOT mode and the gyroscope RPM filter are turned on, making the flight control more stable
Using the latest GL0802 motor with a power input of 2S and a 65mm two-blade propeller, the efficiency is extremely high. Flight control is stable.
8. Double-sided RGB LED ready.
9. The thickness of the fuselage carbon plate material is 4mm, which will not deform or vibrate during high-speed flight.
10. The whole machine is controlled at about 35 g to achieve ultra-high and flexible control. Body weight becomes a professional indicator.
