Only 20g Happymodel Mobula6 65mm Crazybee FPV Racing Drone
Because the MPU6000 is out of production, the flight controller and related Drone will gradually be replaced by ICM20689 or BMI270.
Notice: The Camera of Mobula6 FOV is changed to 140 degree due to the earliest lens was stopped to production .
Please view the new spec from Runcam website https://shop.runcam.com/runcam-nano-3/
Notice: The flight controller of DSM2/DSMX version Mobula6 has been updated to be CrazybeeX DXS V1.0 after Dec.9th 2020 , it has built-in DSM2/DSMX spi receiver , so it won’t come with an external Nano_sp09 receiver.
Click here to buy replace parts together.
Specification:
Brand Name: Happymodel
Model: Mobula6
Item Name: 65mm Crazybee F4 Lite 1S Brushless Whoop FPV Racing Drone BNF
Optional Version: Frsky Receiver ( Compatible with ACCST D8/D16, Recommend D8 mode)
Flysky Receiver ( Compatible with AFHDS and AFHDS-2A Flysky transmitter)
Drone Wheelbase: 65mm
Size: 80x80x37mm
Weight: 20g
Crazybee F4 LiteFlight Controller
Built-in ESC & Receiver & VTX
Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR
(Flysky SPI RX version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000 or ICM20689 or BMI270 (SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in SPI Frsky/Flysky receiver
Built-in 5V 1A BEC
Built-in voltage detection
Onboard Frsky Receiver Version
SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 model
– Frsky_x_lbt Support EU LBT Radio Transmitter
Channels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Onboard Flysky Receiver Version
SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
Failsafe support
Onboard 5A BLheli_S 4in1 ESC
MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Default protocol: DSHOT600
SE0802 19000KV / 25000KV Motor
Model: SE0802
KV: 19000KV / 25000KV Motor
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:Φ1mm
Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm
Weight(g):1.9g
No.of Cells(Lipo):1S only
Gemfan 1219 3-Blade Propeller Brand Name: Gemfan
Center Thickness:5mm
Prop Disk Diameter:31mm
Center Hole Inner diameter:1.0mm
Quantity: 4 CW & 4 CCW
Weight:0.28g
Onboard 5.8G 40CH 25mW VTX Output power: 25mw
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels
With Rac band
Smartaudio ready
Runcam Nano 3 FPV Camera Model: RunCam Nano 3
Image Sensor: 1/3″ CMOS
Horizontal Resolution: 800TVL
Lens : 2.3mm(M6.5) FOV 140°
Signal System: NTSC
Camera Image: 4:3
S/N Ratio: >50dB
Electronic Shutter Speed: Auto
Auto Gain Control (AGC): Auto
Min. Illumination: 0.01Lux@1.2F
D-WDR: Auto
Power:DC 3-5.5V
Current: 110mA@5V 120mA@3.3V
Net Weight: 1.2g
Dimensions: L14mm*W14mm*H9mm
Lipo Battery ( Included)
Continuous Discharge Rate: 30C
Size: 57mmx12mmx7mm
Weight: 8g
Connector: PH2.0
Quantity: 4 PCS
Pacakge Included:
1x Mobula6 1S FPV Racing Drone
4x 1S 300mAh 30C Lipo Battery
1x 1S Lipo/LIHV USB Charger
1x Propeller disassemble Tool
